View unanswered posts | View active topics It is currently 18 Nov 2018, 23:26



Reply to topic  [ 1 post ] 
Pro tools Mackie Mode 
Author Message

Joined: 24 Dec 2013, 20:51
Posts: 4
Post Pro tools Mackie Mode
Hi… So open the editor and open the mackie ctrl v3 bs3 file. Upload it to the hardware and it looks fine. then i open pro tools and select the bitstream as my controller and nothing works. Pro tools says it can't communicate with the device.

im also confused when it comes to uploading stuff… if upload the mackei ctrl v3 file it gets stored into my "user defined" mode. Then why do i need a jackie mode at all? And why does it overwrite the user mode and not only the jackie mode?

And is the unit still supported at all? The software seems very buggy to say the least, and i realise I'm using a non supported OS (mountain lion).

I did a factory reset.
Firmware 1.8
Im on mac
(yes i switched to mackie control mode on the hw).
?
Please help :)


07 May 2014, 07:26
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group.
Designed by ST Software